Engine/Rotax

869 topics in this forum

1. Rotax "Hobbs Time" claims

   By Anticept, May 19, 2023
   • 8 replies
   • 325 views
   • 
   • Anticept
   • May 21, 2023

2. Radiator/Oil Cooler Isolators?

   By FlyingMonkey, May 9, 2023
   • 7 replies
   • 403 views
   • 
   • Roger Lee
   • May 10, 2023

3. Oil change tool

   By sandpiper, May 5, 2023
   • 4 replies
   • 335 views
   • 
   • Anticept
   • May 6, 2023

4. Can you replace a 912 with a 912is

   By Sbailin, May 2, 2023
   • 2 replies
   • 297 views
   • 
   • Roger Lee
   • May 2, 2023

5. Thread Sealant for Fuel Pressure Sender

   By Bulldog, April 26, 2023
   • 4 replies
   • 290 views
   • 
   • Anticept
   • April 26, 2023

6. Dirty plugs on front but clean on back side?

   By procharger, March 25, 2023
   • 7 replies
   • 378 views
   • 
   • FlyingMonkey
   • March 27, 2023

7. Reshimming the gearbox

   By Anticept, October 22, 2022
   • 3 replies
   • 650 views
   • 
   • Anticept
   • March 22, 2023

8. Low fuel pressure on climb out

   By Scrapman1959, March 8, 2023
   • 18 replies
   • 714 views
   • 
   • Madhatter
   • March 19, 2023

9. CTSW Surging

   By tevbax, July 26, 2022
   • 16 replies
   • 594 views
   • 
   • Tom Baker
   • March 17, 2023

10. Two prop strikes ?

    By procharger, January 9, 2023
    • 15 replies
    • 745 views
    • 
    • Anticept
    • March 9, 2023

11. Silicone Coolant Hoses

    By FlyingMonkey, March 5, 2023
    • 5 replies
    • 503 views
    • 
    • FlyingMonkey
    • March 5, 2023

12. Oil thermstat installation photo

    By procharger, February 21, 2023
    • 10 replies
    • 448 views
    • 
    • Jim Meade
    • February 26, 2023

13. Gear box inspection time table

    By procharger, January 9, 2023
    • 6 replies
    • 392 views
    • 
    • procharger
    • January 15, 2023

14. 100 hr rotax inspection

    By 4RJN, January 13, 2023
    • 2 replies
    • 324 views
    • 
    • Anticept
    • January 14, 2023

15. Rocket and chute costs 1 2

    By procharger, January 7, 2023
    • 44 replies
    • 2.1k views
    • 
    • Towner
    • January 13, 2023

16. Just an FYI on fuel block Banjo bolt crush washers

    By Roger Lee, December 31, 2022
    • 1 reply
    • 235 views
    • 
    • Tom Baker
    • December 31, 2022

17. CTLSi Shut Down

    By airhound, December 3, 2022
    • 16 replies
    • 532 views
    • 
    • Tom Baker
    • December 26, 2022

18. Interesting short video on the sprag clutch workings

    By Roger Lee, December 21, 2022
    • 2 replies
    • 285 views
    • 
    • Anticept
    • December 22, 2022

19. 5 Year Rubber Parts for CTLSi 1 2

    By Animosity2k, December 7, 2022
    • 29 replies
    • 1.3k views
    • 
    • Animosity2k
    • December 20, 2022

20. Why does Rotax use a fuel pump?

    By CTSW Bob, December 10, 2020
    • 19 replies
    • 1.2k views
    • 
    • Mike Koerner
    • December 20, 2022

21. Do your purging properly

    By Anticept, November 23, 2022
    • 16 replies
    • 713 views
    • 
    • Jim Meade
    • December 17, 2022

22. Eprop studs

    By procharger, December 15, 2022
    • 6 replies
    • 1.2k views
    • 
    • Tom Baker
    • December 15, 2022

23. E prop install problem

    By procharger, December 15, 2022
    • 0 replies
    • 203 views
    • 
    • procharger
    • December 15, 2022

24. E prop install problem

    By procharger, December 15, 2022
    • 0 replies
    • 119 views
    • 
    • procharger
    • December 15, 2022

25. Coolant Line Routing

    By MileHighCTLS, December 13, 2022
    • 4 replies
    • 441 views
    • 
    • Roger Lee
    • December 14, 2022