Jump to content

Vernier throttle cable stop


Recommended Posts

Vernier throttle cable stop

 

This isn't for a Flight Design, but other LSA with different throttle setups.

 

Here is a picture. See the little brass cable stop on the throttle cable. That will keep you from pulling back too far. Keep it loose until you get the idle set with the stop screws. Then put this up against the bowden cable end and tighten the set screw. Now your Vernier throttle system has a stop that can't come back too far and over power the idle stop screw plate and bend it.

post-3-0-51352600-1388672193_thumb.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...