Palle Posted August 9, 2014 Report Share Posted August 9, 2014 Was out flying today, a hot day in S. California. 5200 rpm, 3,500 ft. Oil Temp 234F, Oil Pressure a steady 62 psi. Flew about 20-30 mins in this configuration. Then reduced throttle to about 4200 rpm and started a descent. A little while after I noticed Oil Pressure showed 7 psi (Oil Temp still good at 234F). I increased throttle and shortly thereafter the Oil Pressure returned to around 62 psi and stayed in that area for the remainder of the flight including the landing pattern. I have had this same issue on 2 other flights, and it seams that on those 2 other flights it also happened when throttle was reduced although I cant remember for sure. I searched this forum and found talk about other OP issues caused by poor grounding of the OP sender. So my question is, could the problem I describe be caused by a grounding issue of the OP sender? Any other cause you can think of? By the way this is on a 2009 Sportcruiser with 175 hours. Thanks for your help. palle Link to comment Share on other sites More sharing options...
Anticept Posted August 9, 2014 Report Share Posted August 9, 2014 7psi is a very low reading that can be caused just by alternator noise. Some senders read voltage (which would bounce all over the place from noise), others read amperage in the milliamp range, which can easily be caused by electrical fields alone inducing current on the wires. Check the ground, then consider the sender. The ground fix takes a few minutes to confirm, the sender can be expensive, so eliminate the simple stuff first. Link to comment Share on other sites More sharing options...
FlyingMonkey Posted August 9, 2014 Report Share Posted August 9, 2014 Yeah, sounds like a poor ground and/or a sender failing. I had similar problems on my CT, my sender was showing 10psi or so intermittently. Link to comment Share on other sites More sharing options...
Roger Lee Posted August 9, 2014 Report Share Posted August 9, 2014 It is one of three things; bad ground, bad sender or you still have the old style oil pressure regulator plug and ball bearing and it is rubbing on the sides or the ball bearing is sticking due to surface tension. Remedies, tighten the 5 grounds nice and tight, replace the $35 sender, replace the oil pressure regulator plug screw, spring and use the new regulator cone. Link to comment Share on other sites More sharing options...
Roger Lee Posted August 9, 2014 Report Share Posted August 9, 2014 Flatten about 1/2 degree and you would be at a pretty good pitch. Link to comment Share on other sites More sharing options...
Palle Posted August 9, 2014 Author Report Share Posted August 9, 2014 Anticept, MrMorton and Roger: thanks for your reply on the Oil Pressure issue. I will show to my A&P on monday. 100Hamburger: it was an 85F day at 5200 rpm, 2 blade Sensenich prop. Compared to your numbers the Oil Temp of 234F is too hot and OP of 62 psi too high. Should I be concerned?, and if so what should be done? Thanks, Palle Link to comment Share on other sites More sharing options...
Anticept Posted August 9, 2014 Report Share Posted August 9, 2014 It is one of three things; replace the $35 sender Labor . That is the expensive part! Link to comment Share on other sites More sharing options...
Tom Baker Posted August 9, 2014 Report Share Posted August 9, 2014 Anticept, MrMorton and Roger: thanks for your reply on the Oil Pressure issue. I will show to my A&P on monday. 100Hamburger: it was an 85F day at 5200 rpm, 2 blade Sensenich prop. Compared to your numbers the Oil Temp of 234F is too hot and OP of 62 psi too high. Should I be concerned?, and if so what should be done? Thanks, Palle I wouldn't be concerned. You are after all flying a different airplane than 100hambuger is, and the numbers are within limits. Link to comment Share on other sites More sharing options...
Palle Posted August 10, 2014 Author Report Share Posted August 10, 2014 Thanks Tom, yes my airplane is a Sportcruiser. Link to comment Share on other sites More sharing options...
Tom Baker Posted August 10, 2014 Report Share Posted August 10, 2014 Thanks Tom, yes my airplane is a Sportcruiser. Palle, did you come out to the Midwest LSA expo a few years ago. Link to comment Share on other sites More sharing options...
Palle Posted August 10, 2014 Author Report Share Posted August 10, 2014 Yes I was there Tom, and we met. Thanks for remembering. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.