Jump to content

Ctsw fuel dipstick improvement


rookie

Recommended Posts

I needed accurate readings to resolve a fuel flow anomally ( rt/lt tank). Black anodized are still not available for the sw so I came up with a gimick that works even better. It's a piece of rubber hose ( preferably dull) that's slit end to end. Slips over the edge of the gage. Very accurate readings in any light. I remove it between readings to retain tension but could be tie wrapped.

post-76-0-28325400-1311336452_thumb.jpg

Link to comment
Share on other sites

Hi Al,

 

I have just been using flat back epoxy paint. I light sanding on the stick to rough it and a little flat black epoxy. It can be removed if you don't like it, but it works just fine. It needs to be an epoxy paint to hold up to the fuel.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...