Search the Community
Showing results for tags 'junkers'.
Found 2 results
Looking for a Junkers Chute & Rear Harness to replace the one removed from our CT2k by a previous (mis-guided) owner. Whilst I have a BRS1350HS that would fit, as the harnesses are different to the Junkers ones factory-installed inside the 'A' pillars (Junkers 40" shorter than BRS ones), I would need to remove them and re-thread the BRS ones through the 'A' pillars - Roger & Corey advised it would be very difficult to do - hence I am looking for Junkers gear ... Any leads gratefully received. David 8-)
History: our CT2k used to have a Junkers chute installed (472.5Kg MTOW) .. the Australian rules changed and the CT2k's MTOW was raised to 544Kg .. an overly-excited compliance-frenzied mechanic removed the chute because the MTOW sticker on the instrument panel had been changed from "450Kg" to "544Kg" ... no chute is better than a 472.5Kg one, right ?! Now: have purchased a new-old-stock BRS 1350HS complete with the 4 kevlar harnesses (ex an FD MC model) and want to fit to our CT2k. Issue: the front harnesses that run inside the 'A' pillars for the Junkers chute are about 40" shorter than the BRS ones and so I want to replace those with the new, higher-capacity BRS ones - ie thread the new BRS harnesses through the 'A' pillars. Question: anyone ever removed the front harnesses ? ... would it be possible to pull through the BRS ones (attached by a cord to the Junkers ones I will be pulling out) ? Many thanks for any thoughts, wisdom, experience. David 8-)