Jump to content

Adding coolant - CTLSi


andyb

Recommended Posts

I've had some minor coolant leakage (a couple of tablespoons) that seems to be coincident with the cold weather and the Tannis heater being turned on prior to flying.  As I understand it, this isn't an issue.

However, the pink fluid level is only about 1/4 inch above the minimum line, so I ordered some of the fluid (Prestone) that's recommend in the Rotax fluids guide.  Is it a problem if I add this fluid on top of the fluid that's already there?  My plane is serviced by a CT/Rotax service center, so I'm confident that the fluid that's already there would be right.

Thanks,

Andy

Link to comment
Share on other sites

On ‎12‎/‎4‎/‎2017 at 10:17 AM, Tom Baker said:

Prestone Dexcool 50/50. Just add to what is in the coolant bottle. I like to fill to the top of the notch in the bottle.  It might also be a good idea to pop the radiator cap off and check the level there to make sure it is to the top.

I purchased the regular Prestone Dexcool.  Can I just mix it with equal parts water?

Andy

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...