Tom Baker Posted September 9, 2018 Report Share Posted September 9, 2018 A question for the group. Would it be worth the trouble to design a modification to allow mounting of this, https://uavionix.com/products/tailbeacon/ , to be installed on the CT? It would require some composite work and painting. It would require a different kit for both the CTSW and CTLS. As a side note for the earlier CTLS's you could also add the tail bumper block at the same time. Link to comment Share on other sites More sharing options...
WmInce Posted September 9, 2018 Report Share Posted September 9, 2018 Tom, I had considered that (CTSW). Are you absolutely sure it will not just slide into the SW hole? Link to comment Share on other sites More sharing options...
Tom Baker Posted September 9, 2018 Author Report Share Posted September 9, 2018 Bill, I am not certain. I was basing it partly on what Al said in the adsb post. It might be easier to make it work on the CTSW. I was basing it on what Al said about the CTLS in the "adsb" post. Link to comment Share on other sites More sharing options...
WmInce Posted September 9, 2018 Report Share Posted September 9, 2018 Link to comment Share on other sites More sharing options...
Tom Baker Posted September 9, 2018 Author Report Share Posted September 9, 2018 It might be as simple as filling and re-drilling the holes, and opening up the center a little bit. Link to comment Share on other sites More sharing options...
WmInce Posted September 10, 2018 Report Share Posted September 10, 2018 Looks like those attachment screws are in need of replacement, eh? . . Link to comment Share on other sites More sharing options...
Tom Baker Posted September 10, 2018 Author Report Share Posted September 10, 2018 Not pretty, but they still work. Link to comment Share on other sites More sharing options...
Farmer Posted September 10, 2018 Report Share Posted September 10, 2018 CTLSi 413L is equipped with 10 inch sky view. it has been fItted with Dynon 2020 unit that cost $609.00, just plugs in, mounted easy, and works well. CTLS 413F also it being fitted with same Dynon 2020 unit after the 10 inch display returns from Washington. A couple of weeks ago it failed to boot up and has been sent off for repair. ADSB Unit is not very big or heavy. Log book entry required as well as professional install. Waiting for TSO on Uavionix tail unit for both Cessna’s. See some of you folks at Page next month. Farmer Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.